DIY Small Patio Side Table Design

Wire Small Patio Side Table

Small patio side table – Everything you need for this job is a few carpentry tools plywood, stain or paint of your choice water sealant and hardware. Pick the five 2-by-4 boards and construct a square table. Add 3-meter long sections with the short sides on the floor parallel to each other three meters apart. Place two of the 2 feet, 9 inches long stretches in between them form a square. Fasten frame together by driving two 2 1/2-inch screws through both ends of the long distances in shorter ones.

Place remain 2 feet, 9-inch long 2-by-4 on the short edge of the center of the frame. Position it so that it runs parallel to the 3-foot sections of the square. Attach this section to the frame by running two 2 1/2-inch screws through the sides of small patio side table of the frame at each end. This section serves as a center support beam.

Place the 3-foot square section of plywood over the frame and set it. Drive 1 1/2-inch screws through the plywood every 6 inches all the way around the edge of the frame including the center beam. Turn the completed section of the top of the small patio side table.

The Best Post  Nice Small Patio Umbrella